Policy
AI Disclaimer
Last updated: 2026-07-20
Loopdraft is an AI-assisted drafting tool for control-engineering documentation. This disclaimer defines the scope and limits of every output and applies whenever you use the studio.
Reference-only, not certified drawings
Every document and diagram Loopdraft produces is an AI-assisted, illustrative and reference-only draft. Outputs are not certified or stamped engineering drawings and must not be submitted directly for construction, installation, safety certification or regulatory compliance.
Not professional engineering advice
Outputs do not constitute professional engineering opinions, structural, electrical or functional-safety (e.g. SIL) assessments, or a guarantee of compliance with any standard (including but not limited to IEC 61131, IEC 61511, ISA 5.1, or any machinery or electrical regulation). Symbols, sizing, tagging and wiring shown are illustrative and must be reconciled with your applicable standards and the actual site.
Competent-engineer review is mandatory
All outputs must be reviewed and signed off by a competent, qualified or chartered engineer before use in any design, construction, installation, commissioning, certification or compliance submission. You remain responsible for verifying every value, tag, signal type and interlock against your project documents.
No field measurement or live control
Loopdraft is online-only documentation software. It takes no field measurements, does not connect to any real equipment, PLC or SCADA system, and performs no real-time or safety-critical control. It does not provide legal, financial or medical advice.
Accuracy of your inputs
Output quality depends on the accuracy and completeness of the information you enter. You are responsible for the correctness and confidentiality of your inputs and for the final engineered result.
Where this disclaimer appears
A short form of this disclaimer is shown beside the tool input and every generated result, and is stamped on generated documents and diagrams. This full version governs all use. Questions: support@faskinconvtrol.shop.
FASKIN CONTROL SYSTEMS ENGINEERING LTD · 8 Irvine Place, Inverurie, Aberdeenshire, Scotland, AB51 4ZZ, United Kingdom · support@faskinconvtrol.shop · +44 7388491941. Governing law: England and Wales.